Installation Guide
Part F
Page 3
Installation Guide
Part F
Page 3
F3
SETTING THE IMAGER ADDRESS NUMBER
Each
FTI 6
has an imager address number, this can be between 0 and 15, the
factory default is one. If the imager is used in a multi imager configuration i.e.
daisy chain, each imager MUST be given a unique imager address number to
avoid conflict.
To set the imager address number:
1.
Ensure that the imager is switched ‘OFF’, open the rear access panel on
the imager.
2.
Rotate the imager address setting switch to the required number, using
a small flat bladed screw driver (refer to Fig. F2).
3.
Close the rear access panel.
4.
Repeat for each imager in a multi imager configuration.
The imager can now be switched ‘ON’.
0 1
2 3 4
5 6
7 8
9
A
B
C D E F
TI990024
1
2
O
N
Imager Address
Setting switch
Memory Cards
Backup
battery cover
Card LED
Serial Comms
Settings switch
Memory Card
Eject Button
Securing
screw
Fig. F2 Setting Imager Address number
NOTE
Imager Address Numbers 10 to 15 are denoted by letters A to F on
the address setting switch, e.g. switch setting B represents imager
number 11.
F3
SETTING THE IMAGER ADDRESS NUMBER
Each
FTI 6
has an imager address number, this can be between 0 and 15, the
factory default is one. If the imager is used in a multi imager configuration i.e.
daisy chain, each imager MUST be given a unique imager address number to
avoid conflict.
To set the imager address number:
1.
Ensure that the imager is switched ‘OFF’, open the rear access panel on
the imager.
2.
Rotate the imager address setting switch to the required number, using
a small flat bladed screw driver (refer to Fig. F2).
3.
Close the rear access panel.
4.
Repeat for each imager in a multi imager configuration.
The imager can now be switched ‘ON’.
0 1
2 3 4
5 6
7 8
9
A
B
C D E F
TI990024
1
2
O
N
Imager Address
Setting switch
Memory Cards
Backup
battery cover
Card LED
Serial Comms
Settings switch
Memory Card
Eject Button
Securing
screw
Fig. F2 Setting Imager Address number
NOTE
Imager Address Numbers 10 to 15 are denoted by letters A to F on
the address setting switch, e.g. switch setting B represents imager
number 11.
