![background image](http://html1.mh-extra.com/html/land-pride/sbl2566/sbl2566_operators-manual_3528969020.webp)
18
Section 4: Adjustments
SBL2566, SBL2574, & SBL2584 Snow Blowers 370-258M
9/18/14
Table of Contents
Discharge Chute & Spout Deflector
!
WARNING
Never rotate chute or spout to throw snow at the tractor,
animals, or people. The Snow Blower is capable of picking up
large solid objects and discharging them out the spout causing
serious bodily injury or death.
Control Switches for Chute Rotation & Spout Deflector
Figure 4-1
Spout Deflector Adjustment
Refer to Figure 4-1:
The end of the spout can be angled up or down to direct
blown snow close or far away.
1.
Stop skid steer/tractor and place in park before
adjusting spout deflector.
2.
Push on “Tilt Up/Down” toggle switch to tilt
deflector spout up and pull toggle switch to tilt
deflector spout down.
3.
Resume snow blowing once new angle is set.
IMPORTANT: Never operate a Snow Blower with
chute throwing snow towards property such as
vehicles, buildings, trailers etc. that can be
scratched, dented or broken by thrown projectiles.
IMPORTANT: Never operate a Snow Blower that
can throw snow towards the skid steer/tractor and/or
operator. If this can happen, make sure the chute
rotation stop is properly repaired before putting the
Snow Blower back into service.
IMPORTANT: Adjustment screws on hydraulic motor
are preset at the factory. Do not change factory
settings. Changing factory settings can cause
structural damage to the Snow Blower.
35810
Connects to 12V
Power Source
Connects to
Wire Harness
Not Used
Section 4: Adjustments
Chute Rotation Gear Adjustment
Figure 4-2
Chute Rotation Gear Alignment
Refer to Figure 4-2:
1.
Stop skid steer or tractor, place in park, shut engine
off and remove switch key.
2.
Loosen all three hex head bolts (#6). Do not remove.
3.
Move hydraulic motor mount (#3) as needed until
drive gear (#2) has full tooth engagement with driven
gear (#1).
4.
Hold hydraulic motor mount (#3) in this position and
tighten all three 3/8"-16 GR5 hex head bolts (#6) to
the correct torque.
If removed, be sure to replace gear guard (#4) with
existing 10-24 pan screws (#5), star washer (#7), and flat
washer (#8). Tighten pan screws (#5).
Chute Rotation Adjustment
Refer to Figure 4-1:
1.
Stop skid steer/tractor and place in park before
adjusting chute rotation angle.
2.
Push on “Rotate Left/Right” toggle switch to rotate
chute to the left and pull toggle switch to rotate chute
to the right.
3.
Resume snow blowing once new chute angle is set.
37220
IMPORTANT: Gear guard (#4) is shown removed for
clarity only. This adjustment can be made without
removing the gear guard. Should the guard be
removed, make certain gear guard (#4) is replaced
before putting Snow Blower back into service.