8
Section 1: Assembly & Set-up
SBL2566, SBL2574, & SBL2584 Snow Blowers 370-258M
9/18/14
Table of Contents
Chute & Spout Assembly
Refer to Figure 1-4:
1.
Remove hex nuts (#10), spring lock washers (#12),
hex head bolts (#7), and rotational stop (#6). Keep
hardware for reuse.
2.
Remove hex nuts (#11), spring lock washers (#13),
hex head bolts (#9), bearing strap (#2A), and chute
bearings (#5). Keep hardware for reuse.
3.
With discharge chute (#1) facing straight forward as
shown. Slide base of chute over UHMW chute
bearing ring (#14) until base of chute is fully under
remaining bearing straps (#2B & #2C) and engage
with sprocket (#4).
4.
Reattach bearing strap (#2A) to snow blower
housing with existing 3/8"-16 x 1 1/2" GR5 bolts (#9),
chute bearings (#5), lock washers (#13), and nuts
(#11). Tighten nuts (#11) to the correct torque.
5.
Reattach rotational stop (#6) to Snow Blower
housing with existing 1/4"-20 x 3/4" GR5 bolts (#7),
rotational stop (#6), lock washers (#12) and hex nuts
(#10). Tighten nuts (#10) to the correct torque.
Refer to Figure 1-5:
6.
Verify stop bolts (#8A & #8B) are left of rotational
stop (#6) as shown.
7.
Tighten hex bolts (#7) to the correct torque.
IMPORTANT: Position chute (#1) facing straight
forward as shown in Figure 1-4 before sliding base
of chute over bearing ring (#14).
Chute & Spout Assembly
Figure 1-4
Rotational Stop Bar Set-up
Figure 1-5
35600
35601
