Land Pride RGR12 Series, Operator'S Manual

Page: 26 / 40

Section 3: Adjustments
Table of Contents
RGR12 & RGA12 Series Rotary Tillers 311-948M 1/7/19
22
Park Stand Adjustment
Refer to Figure 3-3:
WARNING
!
To avoid serious injury or death:
An unsupported parked tiller can tip over. Always use park
stand and/or support blocks to prevent it from tipping over
onto a person.
The park stand mount (#2) should be adjusted up or
down if tiller weight is not resting on park stand (#1) while
unhooked from a tractor.
1. Hook-up tiller to a tractor. Refer to “Hook-Up Rotary
Tiller” on page 12.
2. Lower tiller until skid shoes (#7) are resting on
support blocks. Park stand (#1) should be off the
ground by several inches.
3. Shut tractor down before dismounting using “Tractor
Shutdown Procedure” on page 8.
4. Remove wire retaining pin (#6), bolt (#4), and locknut
(#5).
5. Remove bolts (#3) and lock nuts (#5). Adjust park
stand mount (#2) up or down to realign 2 of 5 holes “A”
with mounting holes “B” in tiller side panel.
6. Attach stand base (#2) to tiller side panel as shown
with 5/16"-18 x 3/4" GR5 hex head bolts (#3) and hex
lock nuts (#5). Tighten locknut to the correct torque.
7. Attach stand (#1) to center holes in park stand
mount (#2) with 5/16"-18 x 2 1/4" GR5 bolt (#4) and
locknut (#5). Draw locknut snug and then back off
1/8 of a turn.
8. Secure park stand in the rotated down position with
wire retaining pin (#6). Make sure wire retainer is
hooked over the end of the pin.
Park Stand Adjustment
Figure 3-3
70290