Section 2: Set-Up of Accessories
1/13/21
14
Manual Offset, Angling and Tilt
Figure 2-1
24999
Blade Angling
Blade Offset
Blade Tilting
SHIPPING BLOCK
DO NOT REMOVE UNTIL AFTER ALL
HYDRAULIC CYLINDERS AND/OR
RATCHET JACK AND MANUAL LINKS
HAVE BEEN INSTALLED.
Section 2: Set-Up of Accessories
Manual Offset, Angling and Tilting
Kit Bundles
300-206A. . . . . . MANANUAL ANGLE LINK ASSEMBLY
300-206A. . . . . MANANUAL OFFSET LINK ASSEMBLY
890-637C . . . . . . . . . . . RATCHET JACK 16.25 - 22.25
The manual links and ratchet jack may be used in place
of the hydraulic cylinders.
WARNING
!
To avoid serious injury or death:
Do not remove shipping block from blade tilt housing until
after all manual links, ratchet jack, and/or hydraulic cylinders
have been installed and cylinders have been charged with oil.
Blade Angling Manual Link
Refer to Figure 2-1:
1. Attach manual angling links (#3 & #4) to the right side
of the Rear Blade as shown with two 1" clevis
pins (#1). Secure with hair pin cotters (#5).
2. Adjust blade angle by removing hitch pin (#2) and
moving outer link (#3) to a different hole. Replace
hitch pin and secure with hair pin cotter (#5).
Blade Offset Manual Link
Refer to Figure 2-1:
1. Attach manual offset links (#3 & #4) to the left side
of the Rear Blade as shown with two 1" clevis
pins (#1). Secure with hair pin cotters (#5).
2. Adjust offset angle by removing hitch pin (#2) and
moving outer link (#3) to a different hole. Replace
hitch pin and secure with hair pin cotter (#5).
Blade Tilting Ratchet Jack
Refer to Figure 2-1:
1. Attach ratchet jack (#6) to the back side of the Rear
Blade as shown with two 1" clevis pins (#1). Secure
with hair pin cotters (#5).
2. Adjust blade tilt by setting the lock on the ratchet
lever and pumping the lever back and forth to raise
one end of the blade higher than the other end.
Reposition ratchet lock and pump lever back and
forth to tilt blade in the opposite direction.
3. Remove shipping block after ratchet jack (#6) has
been installed.
