Land Pride RCM3615, Operator'S Manual

Page: 31 / 64

Section 1: Assembly & Set-up
RC3615 and RCM3615 Series 2 S/N Rotary Cutters 330-502M 12/12/18
27
Table of Contents
Refer to Figure 1-29:
13. Remove park jack (#3) from left-hand wing deck and
attach to jack mount (#12) as shown. Fully insert
detent pin (#8) in jack mount to secure park jack.
14. If needed, realign park jack to be vertical. Refer to
“Park Jack Angle Alignment” on page 28.
15. Unhook hitch safety chain (#4) from tractor.
16. Unhook hydraulic hoses (#7) from tractor duplex
outlet. Insert couplers through spring hose loop (#10)
to keep couplers out of the dirt.
17. Unhook wire harness (#13) from tractor outlet. Coil
wire harness and store over spring hose loop (#10)
with connector hanging down to keep moisture out.
18. Pull back on locking collar (#6) and pull driveline (#5)
from tractor power take-off shaft.
19. Collapse driveline (#5) by pushing tractor end of
driveline toward the splitter gearbox.
20. Rotate driveline hanger (#11) up to position shown
and store driveline on hanger.
21. Adjust park jack (#3) as needed to remove cutter
hitch weight off the tractor drawbar.
22. Remove connecting hitch pin or bolt as follows:
a. For Standard Clevis Hitch, See Figure 1-29:
Remove hairpin cotter (#2) and hitch pin (#1).
a. For LP Performance Hitch, See Figure 1-30:
Refer to Detail B: Remove hairpin cotter (#2) and
hitch pin (#1).
b. For Bar-Tite Hitch, See Figure 1-31:
Remove locknut (#2) and bolt (#1).
23. Restart tractor and drive tractor slowly forward
several feet.
24. Shut tractor down properly before dismounting. Refer
to “Tractor Shutdown Procedure” on page 14.
25. Lower park jack until cutter is resting on its front skid
shoes.
26. Replace connecting pin/bolt (#1) as follows:
a. For Standard Clevis Hitch, See Figure 1-29:
If unhooking standard clevis, replace connecting
pin (#1) in clevis (#9). Secure hitch pin with
hairpin cotter (#2).
b. For LP Performance Hitch, See Detail A in
Figure 1-30:
Rotate clevis (#9) horizontal and flip hitch holder
(#11) up so that its holes are on top as shown.
Insert customer-supplied hitch pin (#1) through
holes in hitch holder (#11). Secure with hairpin
cotter (#2).
c. For Bar-Tite Hitch, See Figure 1-31:
If unhooking bar-tite hitch, remove hitch (#11) from
tractor drawbar and reattach it to hitch (#9) with
removed bolt (#1) and locknut (#2) Screw locknut
on 4 or 5 full turns. Do not torque nut tight.
Unhook Standard Clevis
Figure 1-29
Unhook LP Performance Hitch
Figure 1-30
Unhook Bar-Tite Hitch
Figure 1-31
37594
37631
33870