Section 2: Adjustments
RC3615 and RCM3615 Series 2 S/N Rotary Cutters 330-502M
12/12/18
29
7.
Be sure both sides are equal distance from ground to
continuous hinges and that left and right leveling rods
have equal tension. Re-tighten jam nut (#3).
Level Wing Decks
Each wing section will need adjusting if wing top is not
level with center deck top when wings are unfolded.
1.
With tractor hydraulics, lower wings down. Refer to
on page 35 for instructions on how to
lower wings.
2. Pull cutter straight forward six to ten feet to allow
outer wing wheels to properly align themselves.
3. Check wing tops to see if they are level with the top of
the center deck. If the outer edge of either wing top is
higher or lower than the center deck, then that wing
should be leveled as follows:
a.
If outer wing edge is higher
than the center
deck, loosen jam nut (#1) & rotate turnbuckle (#2)
counterclockwise to lower outer wing edge until
wing is level. Tighten jam nut (#1) to the correct
torque when level.
b.
If outer wing edge is lower
than the center deck,
loosen jam nut (#1) and rotate turnbuckle (#2)
clockwise to raise outer wing edge until wing is
level. Tighten jam nut (#1) to the correct torque
when level.
Level Wing Decks
Figure 2-4
1
2
Counterclockwise Rotation Shown
27926
Center Deck Leveling Rods
Figure 2-3
Jam
1
Right-hand Leveling Rod
Left-hand Leveling Rod
Stroke Control
Spacers
Jam
3
4
3
4
27857
