Section 2: Options, Assembly & Set-Up
1/13/21
RBT3584 & RBT3596 Rear Blades 301-251M
18
Hydraulic Selector Valve (Accessory)
Refer to Figure 2-7:
1. Using selector mount (#5) as a template, locate and
drill two 7/16" diameter holes on right side of hitch
plate as shown.
2. Attach selector mount (#5), to the right side of hitch
with two 3/8"-16 x 1 1/4" GR5 hex head cap
screws (#7), spring lock washers (#8), and hex
nuts (#9). Tighten nuts to the correct torque.
3. Attach double selector valve (#6) to selector
mount (#5) with two 3/8"-16 x 3" GR5 hex head cap
screws (#10), spring lock washers (#8), and hex
nuts (#9). Tighten nuts to the correct torque.
4. Apply Teflon tape to pipe threads on the three
3/4MIJC x 1/2MNPT elbows (#3) and screw them into
the double selector valve as shown. Tighten elbows
to the orientation shown.
5. Apply Teflon tape to pipe threads on the three
3/4MJIC x 1/2MNPT adapters (#1) and screw them
into the double selector valve as shown until tight.
6. Attach the three 3/4FJIC x 3/4MJIC elbows (#2) to
adapters (#1) and tighten to the correct orientation.
7.
Attach frame offset hydraulic hoses (#11) to elbows
located on back of selector valve.
8. Attach hydraulic hoses (#12) from one of the other
cylinders to elbows located on front of the selector
valve.
9. Attach tractor connected hydraulic hoses (#4) to
elbows located on top of selector valve.
10. Thread hydraulic couplings (couplings supplied by
customer) onto hydraulic hoses (#4) and tighten.
Hydraulic Selector Valve Assembly
Figure 2-7
39413
