Section 2: Options, Assembly & Set-Up
1/13/21
RBT3584 & RBT3596 Rear Blades 301-251M
17
Manual Blade Offset, Angling and Tilt Assembly
Figure 2-6
24756
WARNING
!
To avoid serious injury or death:
Do not remove shipping block from blade tilt housing until
after all manual links, ratchet jack, and/or hydraulic cylinders
have been installed and cylinders have been charged with oil.
Manual Blade Angling (Option)
Refer to Figure 2-4 & Figure 2-6:
1. Select correct manual link for blade angling. This is
the link with the first hole 3 9/16" from clevis stop.
Manual Link for Blade Angling
Figure 2-4
2. Attach blade angling links (#1 & #3) to right side of
Rear Blade as shown with two 1" clevis pins (#7).
Secure with hair pin cotters (#6).
3. Adjust blade angle by removing hitch pin (#5) and
moving female link (#3) to a different hole. Replace
hitch pin and secure with hair pin cotter (#6).
Manual Blade Offset (Option)
Refer to Figure 2-5 & Figure 2-6:
1. Select correct manual link for blade offsetting. This is
the link with the first hole 2 7/32" from clevis stop.
24757
Manual Link for Blade Offset
Figure 2-5
2. Attach blade offset links (#2 & #3) to left side
of Rear Blade as shown with two 1" clevis
pins (#7). Secure with hair pin cotters (#6).
3. Adjust offset angle by removing hitch pin (#5) and
moving female link (#3) to a different hole. Replace
hitch pin and secure with hair pin cotter (#6).
Manual Blade Tilting (Option)
Refer to Figure 2-6:
1. Attach ratchet jack (#8) to back side of Rear Blade as
shown with two 1" clevis pins (#4). Secure with hair
pin cotters (#6).
2. Adjust blade tilt by setting lock on ratchet lever and
pump lever back and forth to raise or lower one end
of the blade. Reposition ratchet lock and pump lever
back and forth to tilt blade in the opposite direction.
3. Remove shipping block only after ratchet jack (#8)
has been installed or if installing hydraulic cylinder,
only after the hydraulic cylinder is installed and
charged with oil.
24757
