Section 2: Options, Assembly & Set-Up
1/13/21
RBT3584 & RBT3596 Rear Blades 301-251M
14
Blade Offset Cylinder (Option)
Refer to Figure 2-1:
WARNING
!
To avoid serious injury or death:
Do not remove shipping block from blade tilt housing until
after all manual links, ratchet jack, and/or hydraulic cylinders
have been installed and cylinders have been charged with oil.
IMPORTANT:
Make certain your do not use the 90
degree elbow with a small orifice opening when
assembling blade offset cylinder. The blade tilting
IMPORTANT:
Attach cylinder base to the front
cylinder mount. The base will interfere with the
mainframe if attached to rear cylinder mount.
Blade Offset Hydraulic Cylinder Assembly
Figure 2-1
1. Position hydraulic cylinder (#3) with ports on top as
shown. Select two 90 degree elbows (#4) without an
orifice end and install them into the cylinder ports as
shown. Tighten as needed.
2. Attach hydraulic cylinder to lugs located on left side of
Rear Blade with clevis pins (#2). Make sure hydraulic
ports are positioned on top and cylinder base is
positioned to the front as shown.
3. Secure clevis pins with hair pin cotters (#1).
4. Thread adapter fittings (#5) into the other end of the
hydraulic hoses and tighten.
5. Thread quick disconnect couplers (#8) to adapter
fittings (#5).
6. Screw 78" long hydraulic hose (#6) onto elbow (#4) at
the cylinder base and tighten.
7.
Screw 87" long hydraulic hose (#7) onto elbow (#4) at
the cylinder rod end and tighten.
24753
Section 2: Options, Assembly & Set-Up
