13
8/15/05
Manual No. 701-055M
Land Pride
Assembly Instructions for ST & NT Trekers (S/N 418338-)
Electric Bed Lift
Figure 9C
Final Assembly
Refer to Figure 10C:
1.
Locate T-shaped connector on Electric Lift Wiring
Harness and connect it to the electric lift connector.
T-Shape Connector
Figure 10C
21172
Electric Bed Lift
Electrical End
Electric Lift
Connector
IMPORTANT: The Electric Bed Lift is protected by an
internal clutch in both directions. When the up or
down travel limit is reached, the electric dump will
make a loud “ratchet” noise indicating end of travel
limit has been reached or the Electric Bed Lift is
overloaded. When this noise is heard, release the
switch immediately.
21175
Electric Lift Wiring
Harness
Electric Lift
Connector
Electric Lift Cylinder Installation
!
CAUTION!
Securely support cargo box in the up position to prevent
injury while exchanging lock-up arm with Electric Lift
Cylinder.
!
CAUTION!
Care should be taken when removing the Bed Latch Lock-
Up Arm to prevent injury. Avoid pinch points and make
certain the cargo box does not fall when changing from
Bed Latch Lock-Up Arm to Electric Bed Lift Assembly.
Refer to Figure 8C:
1.
Support the cargo box in the up position with a
device other than the Bed Latch Lock-Up Arm to
relive tension on the connecting pins.
2.
Remove existing cotter pins and clevis pins located
at both ends of the Bed Latch Lock-Up Arm. Remove
lock-up arm from vehicle.
Rocker Switch Connection
Figure 8C
Refer to Figure 9C:
3.
The Electric Bed Lift mounts in the same pin
connections as the Bed Latch Lock-Up Arm was
mounted. First mount the electrical end of the
Electric Bed Lift to the Treker frame with a 1/2" x 49/
64" clevis pin. Secure pin with 5/32" cotter pin. The
opposite end will be attached to the cargo box later.
Cotter and
Clevis Pins
Bed Latch
Lock-Up Arm
Spring Loaded
Latch
Cotter and
Clevis Pins
Latch Pin
21173
■
