4
Manual No. 701-055M
8/15/05
Land Pride
Assembly Instructions for 4210ST & 4410ST Series Trekers
■
Refer to Figure 11A:
4.
Do not connect rod end to cargo box until after
step 5. Extend the rod end of the electric lift until it is
approximately 1" from its connection point located
under the cargo box.
Refer to Figure 10A:
5.
With a secure hold on the cargo box, un-hook the
Bed Latch Lock-Up Arm as shown.
Bed Latch Lock-Up Arm (Lower End)
Figure 10A
6.
Manually align the cargo box connection holes with
the electric cylinder rod end. Attach rod end to the
cargo box with 1/2" x 49/64" clevis pin and 5/32"
cotter pin. Secure pin in place by bending one leg of
the cotter pin.
Rod End Connection
Figure 11A
Bed Latch
Lock-Up Arm
Locking Slot
Disengaged From
Treker Frame
5/32" Cotter Pin
Electric Lift
Rod End
1/2" Clevis Pin
Bed Latch Lock-Up Arm Removal
Refer to Figure 12A:
1.
With a standard screwdriver, pry the torsion spring
off of the Bed Latch Lock-Up Arm.
Un-Hooking Torsion Spring
Figure 12A
Refer to Figure 13A:
2.
Straighten cotter pin and remove. Remove Flat
Washer, Bed Latch Lock-Up Arm, torsion spring and
bushing.
Bed Latch Lock-Up Removal
Figure 13A
Bed Latch
Lock-Up Arm
Flat Bladed
Screwdriver
Torsion Spring
Bed Latch
Lock-Up Arm
Flat Washer
Cotter Pin
Torsion Spring
and Bushing