12
Manual No. 701-055M
8/15/05
Land Pride
Assembly Instructions for ST & NT Trekers (S/N 418338-)
Refer to Figure 6C:
5.
Located behind the dashboard is the electric lift
electrical connector which can be identified by its two
green wires and one black wire. If the connector
cannot be located, then remove the glove box by
prying the glove box from the dashboard with a
screwdriver at its rivet locations. Once the connector
is located, pull it through the mounting panel cutout
and thread it through the dump mounting panel.
Electrical Connector & Mounting Panels
Figure 6C
Refer to Figure 7C:
6.
With the electrical connector threaded through the
dump mounting panel, press the side by side
mounting panels back into the dashboard.
7.
Align rocker switch terminals with electrical
connector sockets and plug the switch into the
connector. Do not press the rocker switch into the
dump mounting panel until after the electric lift
cylinder has been installed and after the correct
switch orientation as been determined.
Rocker Switch and Electrical Connector
Figure 7C
Electrical Connector
Behind Dashboard
Mounting Panel
Mounting Panel Cutout
21184
Electrical Connector
From Behind Dashboard
21182
Rocker Switch
Mounting Panel
Rocker Pad
Oval Shaped Connector
Figure 4C
Refer to Figure 5C:
3.
Remove the two panel plugs from the aux (auxiliary)
and dump mounting panels located on the
dashboard by prying a screwdriver below each plug.
4.
Pry out the side by side aux and dump mounting
panels with a screwdriver by wedging the
screwdriver under the bottom end of the dump
mounting panel. Push up under the mounting panel
housing to release the mounting panel’s hidden snap
latch and pry out approximately 1/4" from the
dashboard. Repeat this procedure below the aux
mounting panel, above the aux mounting panel and
then above the dump mounting panel. Continue
prying the aux and dump mounting panels out in this
counterclockwise fashion until both mounting panels
are removed from the dashboard.
Aux and Dump Mounting Panels
Figure 5C
21176
Oval Connector
Attached to
Main Wiring Harness
Two-Prong Connector
Attached to Electric
Lift Wiring harness
Dump
Mounting
Aux
Mounting
Panel
Insert a screwdriver under the mounting panels where
indicated by the white arrows to release the panel’s
hidden snap latches and to pry the panels out.
21181
■