2
Manual No. 313-473M
3/18/10
Land Pride
Assembly Instructions
Disassembly of Back and Right Hand Side
Figure 2
Existing Drive Chain Cover
Figure 3
26936
26923
Assembly Instructions
Disassembly of Back & RH Side
Refer to Figure 2:
1.
Remove slow moving vehicle (SMV)
sign (#13) from back of main seed box. Save
SMV sign for reattachment later.
2.
Plug sign mounting holes in main seed box
with removed 1/4"-20 x 5/8" round head
screws (#3), flat washers (#9) and nuts (#8).
Tighten nuts to the correct torque.
3.
Remove sling bracket (#2) from the right
hand side of the seed box.
4.
Plug sling bracket mounting holes by
reinstalling existing 1/2"-13 x 1" GR5 hex
head cap screws (#5), lock washers (#10)
and nuts (#7). Tighten nuts to the correct
torque.
5.
Loosen hand knobs (#12) and remove chain
guard (#11). Save existing chain guard for
reuse.
6.
Remove roller chain (not shown) from
agitator sprocket (#1). Do not remove chain
from any of the other sprockets.
7.
Remove bolt (#4) and sprocket (#1) from end
of agitator shaft. Save bolt and nut for
installation of new double sprocket later.
Rework Existing Drive Chain
Cover
Refer to Figure 3:
1.
Measure up from the rear slot 7 1/4" as
shown and make a horizontal line 2" long at
this location.
2.
Measure up from the front slot 5 3/32" as
shown and make a second horizontal line 2"
long at this location.
3.
Scribe a line 2" in from the guard edge
starting at the first horizontal line and
continuing up around the top and back down
to the second horizontal line.
4.
Cut relief notch in chain cover as shown to
remove 2" of material from the first horizontal
line to the second horizontal line.
