4
Manual No. 313-473M
3/18/10
Land Pride
Assembly Instructions
Small Seeds Box Mounting (APS1560 Shown)
Figure 7
26924
Seed Box Rework, Right Hand Side
Refer to Figure 6:
1.
Locate, mark and drill two 21/32" diameter holes in
the upper left corner of the right hand end panel.
2.
Locate, mark and drill two 13/32" and two 9/32"
diameter holes in the upper right hand end panel.
3.
If not present, drill two 13/32" diameter holes in the
lower right corner of the right hand end panel.
Small Seeds Box Mounting
Refer to Figure 7:
1.
Attach small seeds box to main seed box by inserting
5/16"-18 x 3 1/2" GR5 cap screws (#5) through
backing plates (#2A), main seed box back panel,
spacer tubes (#1), small seeds box front panel, lock
washers (#11) and hex nuts (#7). Draw nuts up snug.
2.
Insert 5/16"-18 x 1" GR5 cap screws (#4) through
small seeds box front panel, main seed box rear
panel, backing plates (#2B), lock washers (#11) and
hex nuts (#7).
3.
Tighten all installed nuts (#7) to the correct torque.
4.
Attach SMV mounting bracket (#13) to small seeds
box with 5/16"-18 x 1/2" GR5 cap screws (#6) and
locknuts (#9). Tighten nuts to the correct torque.
5.
Attach removed SMV sign (#12) to mounting
bracket (#13) by inserting 1/4"-20 x 5/8" GR5 round
head screws (#3) through flat washers (#10), SMV
sign (#12), SMV mounting bracket (#13) and flat
washers (#10). Secure SMV sign with locknuts (#8).
Tighten nuts to the correct torque.
Main Seed Box Rework - Right Hand Side
Figure 6
26922
*
The two holes marked with an (*) must be drilled only if
your seeder’s serial number is 543361 or lower. Seeders
with serial number 543362 and higher are manufactured
with the two holes included.
