![background image](http://html1.mh-extra.com/html/land-pride/7000-series/7000-series_operators-manual_673062027.webp)
Transporting the No-Till Drill
9/16/20
7000 Series 556-433M
23
Rear Attachment Settings
Spike Drag Settings (Option)
11. On the spike drag, start with 5 links hanging from the
chain in drag arm bottom slot (1). (This is the starting
point for worst conditions). The cleaner the ground,
the shorter the pull chain may be pulled up. On the
spike drag, one of the links (2) in the first row of
angles is turned over. This allows the trash to start
flowing through the drag easier by changing the
angle of the first row of teeth. Always make sure that
the drag is never pulling off of the hang chains. If so,
shorten pull chains.
Heavy Coil Tine Settings (Option)
12. To adjust down pressure loosen the jam nut (5), and
screw the spring bolt (6), in to put more down
pressure on the drag, or adjust the bolt out to have
less down pressure. Re-tighten the jam nut (5), to
secure your adjustments. The spring will be pre-set
to 3 - 3
1
2
” of bolt left to adjust.
13. To change angle of coil tine, rotate the locking pin (3)
and move the adjustment lever (4) forward or
backwards. Moving the lever forwards towards the
front of the machine will allow residue to flow through
the drag easier. Moving the lever backwards away
from machine makes the drag more aggressive.The
adjustment lever has 4 positions and will change the
coil tines several degrees.
14. Rotate the locking pin (3), back to its engaged
position when the desired angle is set.
Figure 14
Spike Drag Settings
34861
1
2
Figure 15
Heavy Coil Tine Adjustment Lever
43422
3
4
5
6
Summary of Contents for 7000 Series
Page 36: ...Table of Contents ...
Page 37: ...Table of Contents ...