Preparation and Setup
9/16/20
7000 Series 556-433M
13
Clevis Hitch
The base hitch must be upright (with the recessed notch
on the bottom) for this configuration. this places the
tongue weight on the base hitch, and not the clevis. (13).
10. Select one each:
(13) 890-798C HITCH CLEVIS
(11) 802-487C HHCS 3/4-10X6 GR8
(12) 803-367C NUT HEX TOP LOCK 3/4-10PLT
11. With the square-shouldered end of the clevis (13)
up, fully seat the clevis in the upright base hitch (18).
Insert the Grade 8 bolt (11) from below. Secure with
lock nut (12).
Hitch Failure Hazard:
Install the hitch base and assemble the clevis parts as shown.
Incorrect installation or assembly may result in failure of the
clevis bolt, leading to hitch failure. This could result in a
serious highway accident or severe machine damage.
Category III Hitch
The base hitch (18) must be inverted (with the recessed
notch on the top) for this configuration. Set the
V-block (14) to allow some vertical articulation of the
draw bar pin. Always use at least one cushion (15).
12. Select one of each
(16) PPI-302V TOP PLATE - CAT 3
(14) PPI-203VR V-BLOCK
(10) 802-383C HHCS 3/4-10X3 GR5
and two:
(15) PPI-205H CUSHION
13. Set the cushions inside the hitch recess, just forward
of the vertical bolt hole. Position the V-block (14)
forward of the cushions and check the size of the
resulting pinning hole. Remove a cushion (15) if
needed.
14. Add the top plate (16). Secure from below with Grade 5 bolt (10).
Figure 6
Configure Hitch
31740
43410
31741
18
10
16
15
14
11
13
12
Summary of Contents for 7000 Series
Page 36: ...Table of Contents ...
Page 37: ...Table of Contents ...
