Assembly Instructions
1/20/21
Third Function Valve Kit #380-168A & #380-335A Installation Instructions Manual No. 380-169M
5
Bulkhead Mount with Flat Faced Couplers
Figure 8
Cross Beam Mount Assembly
Refer to Figure 7 on page 4, Figure 8, & Figure 9:
1. Remove existing hardware (#21, #22, & #23) from
the right-hand side of loader cross tube “F”.
2. Orient as shown in Figure 9, attach bulkhead
mount (#2) to the right-hand side of loader cross tube
“F” with removed hardware (#21, #22, & #23).
3. Tighten replaced hardware (#21, #22, & #23) to the
proper torque.
4. Attach 86" long hoses (#19) to elbows (#16).
Cross Beam Mount Assembly
(Shown with all male Pioneer Couplers)
Figure 9
73071
2
F
21
22
23
19
37359
16
41
A
19 B
42
12
26
Hydraulic Hose Routing
Figure 10
Hydraulic Hose Routing
Refer to Figure 1 on page 2, Figure 9, & Figure 10:
1. Route hoses (#19) along loader arm and through
loader hose loop bracket “H” to the third function
valve (#9).
2. Slide black dust plug (#14) on free end of
hose (#19A) and attach female coupler (#26) to the
hose.
3. Slide green dust plug (#27) on free end of
hose (#19B) and attach female coupler (#26) to the
hose.
4. Connect hose (#19A) to quick coupler (#12) in
port “A”, on valve block (#9).
5. Connect (#19B) hose to quick coupler (#12) in
port “B”, on valve block (#9).
6. Tighten elbows (#16) to adapters (#30).
7.
Tighten hoses (#19) to elbows (#16).
8. Secure hydraulic hoses (#19) as needed with
cable ties (#3).
19
H
G
37360
