Assembly Instructions
1/20/21
Third Function Valve Kit #380-168A & #380-335A Installation Instructions Manual No. 380-169M
3
Steel Tube Location
Figure 3
Connect to Power Beyond Ports
Refer to Figure 1 on page 2, & Figure 3, Figure 4, &
Figure 5:
1. Place chocks in front and back of the tractor’s front
wheels.
2. Loosen lug nuts on the right rear wheel. Do not
remove lug nuts at this time.
3. Jack right rear wheel off the ground and place a jack
stand under the right rear axle.
4. Lower right rear axle onto the jack stand. The wheel
should still be slightly off the ground. Make sure jack
stand is secure and will not slip out from under the
tractor axle.
5. Remove lug nuts and right rear wheel.
Refer to Figure 3:
6. Locate and remove steel tube (#46) that is connected
to the power beyond port (P1) and return to tank
port (T1).
Refer to Figure 1 on page 2, & Figure 4:
7.
Install the larger hydraulic adapter (#10) into the
power beyond port on the loader valve and
9/16" MJIC x 9-16" FJIC elbow (#18) to adapter (#10).
8. Connect hydraulic hose (#17) from “P” port to
elbow (#18). Tighten hose to the elbow.
46
P1
74895
T1
IMPORTANT:
Land Pride recommends that your
dealer connect hydraulic hoses (#11 & #17) to your
tractor’s power beyond port and (P1) and return to
tank port (T1). Improper hook-up could cause
damage to your tractor.
IMPORTANT:
DO NOT connect hydraulic hoses
(#11 & #17) to the loader valve and power beyond
port if the outer block feeds equipment mounted on
the back of the tractor such as a backhoe. The
instructions below do not apply in this situation.
Have your nearest dealer hook-up these hoses.
Improper hook-up can damage your tractor.
Connect 48" Long Hose
Figure 4
Tank Port (B3350 tractor Shown)
Figure 5
Refer to Figure 2 on page 2, & Figure 5:
9. Remove back right seat support stud (#43).
10. Install 3/8" MBSPP x 9/16" MJIC elbow (#20) to
return to tank port (T1) on the tractor where the steel
tube connecting power beyond ports was.
11. Position elbow (#20) as shown and tighten.
12. Reattach seat support stud (#43) to mount (#44) and
tighten.
13. Connect hydraulic hose (#11) from “T” port to
elbow (#20).
14. Secure hoses (#11 & #17) to underside of tractor with
cable ties (#3)
15. Replace right rear wheel and screw lug nuts on until
snug.
16. Jack axle up and remove jack stand.
17. Lower tractor down and tighten lug nuts in a
crisscross pattern. Refer to tractor Operator’s Manual
for proper torque value.
18. Remove chocks.
19. Check tractor hydraulic fluid level. If low, add
recommended hydraulic fluid. Refer to your tractor
Operator’s Manual for recommended hydraulic fluid
and procedure for checking hydraulic fluid level.
10
18
17
74896
P1
43
T1
44
39150
20