Assembly Instructions
4
Third Function Valve Kit #380-168A & #380-335A Installation Instructions Manual No. 380-169M
1/20/21
Control Lever Assembly
Figure 6
Control Lever Assembly
Refer to Figure 1 on page 2, & Figure 6:
1. Remove existing knob (not shown) from end of
control lever “D”.
2. Install new control handle (#13) over end of control
lever “D” with push buttons facing operator.
3. Tighten set screws (#34) against control lever “D”.
Tighten jam nuts (#33) to secure set screws (#34).
4. Thread wiring harness (#40) through rubber
cover “E” in Figure 6 and to wiring harness (#32)
shown in Figure 1 on page 2.
5.
Reference Wire Connections “A”:
Connect one
black wire in harness (#40) to one black wire in
harness (#32) and the other black wire in
harness (#40) to one white wire in harness (#32).
6.
Reference Wire Connection “B”:
Connect the two
red wires in harness (#40) to one end of wire (#35)
with fuse holder (#15), and the opposite end of wire
(#35) to the positive (+) post on the battery.
7.
Reconnect disconnected negative battery wire to the
battery’s negative (-) post.
8. Secure wiring (#32, #35, #40) with cable ties (#3) as
needed.
Push
Buttons
40
33
13
D
E
34
37358
Bulkhead Mount with Pioneer Couplers
Figure 7
Bulkhead Mount Assembly
Refer to Figure 7 & Figure 8 on page 5:
1. Attach bulkhead fittings (#30) to bulkhead
mount (#2). Tighten bulkhead locknuts to bulkhead
mount (#2).
Refer to Figure 7:
2. When installing the kit with pioneer couplers, slide
green dust plug (#27) on bulkhead fitting (A), and
black dust cap (#4) onto bulkhead fitting (B).
Refer to Figure 7, Figure 8, & Figure 9 on page 5:
3. Attach female coupler (#26 or #41) to bulkhead
fitting (#30B). Tighten and secure couplers.
4. Attach male coupler (#12 or #42) to bulkhead
fitting (#30A). Tighten to secure coupler to
bulkhead fitting.
5. Attach elbows (#16) to the fittings (#30). Do not
tighten elbows at this time.
73070
B
A