11
Section 1: Assembly and Set-Up
8/15/12
RCR3596, RCRM3596, RCR3510 & RCRM3510 Rotary Cutters 312-517M
Table of Contents
RCR(M)3510 Hitch Assembly
Figure 1-5
RCR(M)3596 Hitch Assembly
Figure 1-4
25516
(#7). Make sure level rod adjusting nuts are threaded
the same distance on both rods. This will ensure a
level unit.
3.
Rotate hose holder (#9) up 90 degrees and tighten
hardware that is securing hose holder bracket.
4.
Route hydraulic hose through loop of hose
holder (#9).
5.
Remove parking jack (#10) from its storage position
on the deck and attach to tongue (#1). Secure with
attached pin (#11). Adjust jack to desired height.
Pull-Type Cutter
Hitch Assembly
Refer to Figure 1-4 for RCR(M)3596 hitch assembly
and Figure 1-5 for RCR(M)3510 hitch assembly:
1.
Assemble tongue (#1) to the deck using hitch pins
(#2), spacer tubes (#3) and linch pins (#4).
2.
Attach level rod assemblies (#8) to tongue (#1) using
clevis pins (#5), flat washers (#6) and cotter pins
NOTE: Do not tighten hardware to the correct
torque until assembly is complete.
