LANCOM 1722 VoIP – LANCOM 1724 VoIP
Chapter 3: Basic configuration
57
EN
Enable DHCP server?
Disable the DHCP server function in the LANCOM Router if you would like
to have a different DHCP server assign the IP addresses in your LAN.
3.1.2
Configuration protection
The password for configuration access to the LANCOM Router protects the
configuration against unauthorized access. The configuration of the router
contains a considerable amount of sensitive information such as your Internet
access information. We therefore strongly recommend protecting it with a
password.
The setup wizard for the basic configuration automatically disables remote
configuration access via ISDN, thus protecting your configuration against
tampering. ISDN remote configuration access can be enabled at any time
using the security wizard (see ’Have you permitted remote configuration?’
3.1.3
Settings for the DSL connection
For the WAN connection it may be necessary to enter the transfer protocol
being used. The wizard will e.g. automatically enter the correct settings for
major DSL providers. You only need to enter the protocol used by your access
provider if the wizard does not list your provider.
3.1.4
Settings for the ISDN connection
Set up the basic configuration of your ISDN connection if required. You will
need the following data:
One or more ISDN MSNs on which the router will accept calls. MSNs are
ISDN subscriber numbers that are assigned to you by your telephone pro-
vider. They are normally entered without an area code. These numbers are
only relevant for the router functions (LAN to LAN coupling, RAS), not for
remote configuration and LANCOM VPN Option.
A dialing prefix for access to the public telephone network. This is nor-
mally required only when using an ISDN PBX. '0' is the usual prefix. It is
used for all outgoing calls.
Finally, you should know whether your telephone provider transmits an
ISDN connect-charge pulse. This signal can be used LANCOM Router for
connect-charge budgets and the accounting function.
