4
Merchandiser Installation/Removal
1. To remove the merchandiser, first detach the left and right
side of the merchandiser from the connection tabs by pulling
away from the unit.
If installing a Scotsman
®
icemaker, Lancer recommends
setting the auto agitation time to every 60 minutes. To
adjust the agitation time, set the dip switches located in
the control box behind the merchandiser. See the DIP
Switch Legend diagram on page 12 of this manual for
reference.
NOTE
A
B
A. Detach from
Connection Tab
B. Merchandiser
A
B
A. Position Over
Valve Plates
B. Merchandiser
A
B
C
A. Rotate from Bottom
B. Merchandiser
C. Connection Tab
B
A
B
A. Push in Tab
B. Side Bracket
5. Ensure the icemaker is installed properly to allow for removal
of the Merchandiser.
6. Ensure manual fill is accessible.
7. Clean and maintain icemaker per manufacturer’s
instructions.
5. Position the lower edge of the merchandiser over each of the
valve plates.
3. Lift the merchandiser straight up to detach from the top of
the ice bin and remove from the unit.
4. To install the merchandiser, firmly push the connection tabs
toward the center of the unit in order to create a clear path
for the install.
Installing an Icemaker (if necessary)
When installing an icemaker on the dispenser, use a
bin thermostat to control the ice level (see below). This
will prevent damage to the dispensing mechanism. The
bracket for mounting a thermostat is located in the ice
bin. During the automatic agitation cycle and while
dispensing ice, ensure there is adequate space be-
tween the top of the ice level and the bottom of the
icemaker so the ice can move without obstruction.
Contact your icemaker manufacturer for information
on a suitable bin thermostat.
!
ATTENTION
1. Install the icemaker per manufacturer specifications. Points
of consideration include drainage, ventilation, and drop
zones.
2. An adapter plate is required when installing an icemaker.
Contact your Sales Representative or Lancer Customer
Service for more information.
3. A bin thermostat is required in order to control the level of ice
in the dispenser (Refer to ATTENTION above). Contact your
icemaker manufacturer to obtain the correct bin thermostat.
4. Bin thermostat should be a minimum of 2” below the top
edge of the dispenser. The preferred location of the bin
thermostat is on the left side wall.
Failure to use an ice bin thermostat will not only void
your IBD’s warranty but will result in the inability to
control the level of ice in the ice bin which can cause
damage to your dispenser.
!
ATTENTION
2. Rotate the merchandiser, away from the unit, from the
bottom to disengage from valve block.
4”
Attach Bin Stat Bracket As Shown
Recommended Bin Stat Attachment
Bulb
Tube
