LEGACY FG
033-0004
Page S.30
REV. 0/04-23-2007
Lancair International Inc., Represented by Neico Aviation Inc., Copyright 2007 Redmond, OR 97756
S.7.B Installing the Idler’s Base Bracket
When you have determined that the idler’s base bracket is
in the proper location, finish the installation using these
steps.
Adjust the bracket placement for optimal clearance
between the push-pull tube and the upper gear weldment
while the idler arm is vertical.
Steps...
1. With the base bracket still clamped in place, mark the
four locations for the bolt holes.
Your four marks should be thoroughly tested. If you
are not positive, repeat the instructions in
on the previous page.
2. Drill through the spar at each of the bolt hole locations.
3. Bolt the idler’s base bracket in place using the
following parts:
Bolt, MS24694-S104
Washer, AN960-416
Nut, AN365-428A
Figure S.7.B.1 Assembled idler arm
Forward
Figure S.7.B.2 Location of the idler’s base bracket
2.25” (63 mm)
1” (25 mm)
Check clearance.
Should be
approximately 1/8”.
Base bracket for aileron
idler, 209-0001
Inboard push-pull tube
Forward
Rod-end bearing, F35-14
Witness hole
