LEGACY FG
033-0004
Page S.9
REV. 0/04-23-2007
Supplement–Legacy Fixed Gear
Lancair International Inc., Represented by Neico Aviation Inc., Copyright 2007 Redmond, OR 97756
Steps...
1. Hold the upper-leg link (7707) in place against the
upper-leg attachment.
2. Check the aft wing spar and determine how much of a
release needs to be installed.
3. Tape the end of upper-leg link with clear tape. Add
flox and set the link in place. Use a tongue depressor to
create a clean fillet around the end of the link.
4. Install the six bolts that secure together the two
sections of the upper-leg attachment.Secure each bolt.
5. From the inside, mark the four bolt locations for
securing the upper-leg link’s aft end to the inside of the
aft wing spar.
6. Mark and back drill four holes.
7. Insert the four bolts from the inside and secure them on
the aft outside of the wing stub.
Now you are ready to check the toe-in angle as described in
the next section,
Figure S.4.B.4 Upper-leg link held in place between upper-leg attachment and aft wind spar
Upper-leg link, 7707.
Upper-leg attachment
7703-01
Bolt, AN5-6A
Washer, AN960-516
Nylock nut, AN365-528A
(6 pieces of each)
Release tape end of
upper-leg link.
Bolt, AN4-12A
Washer, AN970-4
Nuts AN365-428A
(4 pieces of each)
Aft wing spar
Area for release
