LEGACY FG
033-0004
Page S.6
REV. 0/04-23-2007
Supplement–Legacy Fixed Gear
Lancair International Inc., Represented by Neico Aviation Inc., Copyright 2007 Redmond, OR 97756
S.4.B Installing the Gear Leg
Steps...
1. Locate the upper-leg attachment on the inside of the
forward wing spar. Position using the following
guidelines:
• Set as low as possible on the wing spar. Leveling
may require up to two tongue depressors between
the wing floor and the bottom of the upper-leg
attachment on the inboard side.
• Locate the inboard edge at 3” (75 mm) outboard
from the inboard spar bolt hole in the forward wing
spar.
See the dimension location in Figure S.4.B.1.
2. Verify the position of the upper-leg attachment by
testing the aileron push-pull tube for clearance. The
aileron push-pull tube must clear the upper-leg
attachment.
For information on the location and assembly of the
aileron push-pull tube, see Chapter 6, Section B in the
Legacy Assembly Manual
.
3. Clamp the upper-leg attachment in place.
4. Cut the gear leg hole so it is large enough to slide the
gear leg in place.
5. Insert the gear leg through the opening and into
position in the upper-leg attachment. See Figure
S.4.B.1.
6. Insert the bolt (AN4-22A) that holds the gear leg in
place.
Figure S.4.B.1 Locating the gear leg opening and attaching the upper-leg attachment.
3” (75 mm)
Two tongue depressors
should fit between wing
floor (spar cap) and
upper-leg attachment
Aileron push-pull tube.
Forward wing
spar
Upper-leg
attachment
Gear leg
Angle should be 50
°
.
Gear leg opening
Check clearance!
Check clearance!
Set as low as possible on
the wing spar.
Inboard spar
bolt hole
50
°
