Lancair International Inc., Represented by Neico Aviation Inc., Copyright 2008 Redmond, OR 97756
Chapter 1
Page 1.12
REV. 2nd Ed./08-15-06
Introduction to the Lancair ES FastBuild Kit
ES
two rotary cutters, one can be used for dry fiberglass cloth cuts and the other for cutting wetted
out cloth.
Rivet squeezer
A rivet squeezer will save you hours when you are installing rivets.
Cleco™ pliers and bits
You will need a Cleco™ pliers tool and about 50 of the 1/8” Cleco bits (copper). A Cleco tool is
simply a special pair of pliers used to fasten together the sheet metal. Clecos are a sheet metal
fastening device used extensively in the aircraft industry. Clecos and Cleco pliers are available
from aircraft supply stores or catalogs (ours included).
Digital level
A digital level has an LCD readout instead of a bubble. On some digital levels the center pops
out to become a small, six inch level that's extremely handy for measuring control surface
throws, seat back angles, firewall angles, engine thrust lines, etc., all with an accuracy of 1/10th
of a degree.
KCI carries a digital level. It is a great tool but always remember to re-calibrate the level module
when you turn it on, otherwise you could be off by a couple of degrees.
Air compressor
This tool is useful in any shop. You will find many uses for it during the construction of your
airplane, particularly when you want to remove sanding residue from surfaces and during the
painting prep. steps.
Tubing bender
You will need a tubing bender for 1/4” O.D. aluminum tubing.
