Lanaform Dolce, Manual, Page: 4 / 32

4
EN - INTRODUCTION
Thank you for choosing Dolce by Lanaform®.
Providing real foot care, this Dolce pedicure device will make your feet
naturally soft. Ideal for damaged, dry and rough feet, this exfoliating care
has been designed to smooth the skin of your feet and heels. Thanks to its
rotating abrasive disk, dead skin on your feet will be easily eliminated.
PLEASE READ ALL THE INSTRUCTIONS BEFORE USING YOUR DEVICE,
ESPECIALLY THIS BASIC SAFETY INFORMATION:
• This device is not intended for use by people, including children, with
limited physical, sensory or mental abilities, or by people lacking
experience or knowledge, unless they have been supervised or instructed
beforehand on how to use the device by someone responsible for their
safety. Children should be supervised to ensure that they do not play
with the device.
• Only use this device according to the instructions given in this manual.
• Check that your mains voltage is the same as that of your device.
• Keep the device away from heat sources such as stoves, radiators, etc.
• Do not leave the device in direct sunlight.
• Do not connect or disconnect the plug or electrical transformer of the
device with wet hands.
• If the power cable is damaged, it must be replaced by a similar cord
available from the supplier or the latter’s after-sales department.
• Unplug the device before cleaning it.
• Do not wash the entire unit with water and do not immerse it in water.
Consult the cleaning instructions in this manual.
• Unplug a device that has fallen into water immediately before retrieving it.
• An electrical device should never remain connected unsupervised.
Disconnect it when you are not using it.
• Keep the power cable away from hot surfaces.
• Never use this device in a room where aerosol products (sprays) are used or
in a room where oxygen is being administered.
• Do not use this device under a cover or under a cushion. Excessive heat can
cause fire, electrocution or injury.
• Never use this device in a room whose temperature exceeds 40°C.
• If the device is placed in a room where the temperature is low, you are
advised to wait for several minutes before using the device in a warmer
environment. Indeed, drops of water may appear due to condensation, in
which case your device may not work properly.
• Do not put items of clothing or towels under or on top of the device.
• This device is designed for domestic use only.
• If you are concerned about your health or are taking medical treatment,
consult a doctor before using this device.
• If you experience any pain when using this device, stop using it
immediately and consult your doctor.
• Do not use this device for more than 30 minutes at a time. Wait for one
hour between each use.
• Never use this device on a body part that is swollen or inflamed or if you
have a skin rash.
• Do not use this equipment without consulting your doctor in the following
cases: if you are pregnant or breast-feeding, if you have diabetes, if your
skin has tattoos or moles, if you have skin cancer, if you have unusual skin
discolouration, if you take medicine or if you have a foot problem such as
nail fungus or over-sensitive skin. If you are unsure, consult your doctor
before using Dolce.
COMPONENTS OF THE DEVICE (SEE ILLUSTRATION «A» AT THE
BEGINNING OF THESE INSTRUCTIONS):
1. Main body (1)
2. Protective ring (2)
3. Cover (3)
4. Receptacle for callused skin (4)
5. Abrasive disk (5)
6. Mains adaptor (6)
7. Cleaning brush (7)
INSTRUCTIONS FOR USE (SEE ILLUSTRATION «B» AT THE BEGINNING
OF THESE INSTRUCTIONS)
HOW TO USE
For an optimum result, soak your feet in warm water for 15
minutes and dry them before using Dolce. Rinse them to finish the
treatment and moisturise them with a nourishing cream.
1. Open the cover. (a)
2. Connect the adaptor to the electric socket and connect the other side to
the socket on the main body.
3. Put the lever in position 1. (b)
4. Take the main body and apply it onto your feet using circular movements
across your calluses to remove dead skin. Do not stay in the same place
but rather move the device across a large surface area of skin so as to
not irritate it.
5. If you have thick calluses, you can put the lever in position 2. (b)
6. Keep the upper part of the protective ring aimed at your face and adjust
the angle of the main body’s nozzle to keep residues from escaping
towards your face.
7. After use, put the lever in off position and unplug the adaptor from the
electric socket and device.
DISMANTLING AND ASSEMBLY
1. Turn the protective ring clockwise to separate it from the main body.
(c & d)
2. Lift the abrasive disk vertically to separate it from the receptacle for
callused skin. (e)
3. Vertically remove the receptacle to separate it from the main body. (f)
4. Empty the receptacle of callused skin and use the cleaning brush to
finish. (g)
5. To re-assemble the device, first connect the receptacle to the body of the
device, verifying the direction of the magnet. (h)
6. Place the abrasive disk on the receptacle, making sure to properly
secure it. (i)
7. Align the circular bulge of the main body with that of the safety ring and
then turn the ring counter-clockwise. (j &k)
8. Put the cover back on if you are not using the device. (l)