Lampoassa ELI 60-90, User Manual

Page: 28 / 62

28
100% GEOTHERMAL HEAT
MAINTENANCE
This screen allows checking analog input statuses.
Analog Input (B)
1 Hot gas sensor 1 6 Circuit 1 outgoing temperature sensor
2 Not in use 7 Circuit 2 outgoing temperature sensor
3 Boiler top part temperature sensor 8 Circuit 3 outgoing temperature / Me-
asurement of domestic hot water sensor
4 Boiler foot part temperature sensor 9 Not in use
5 Outside temperatur sensor 10 Brine circuit heat
Analog outputs
This screen allows checking analog output statuses.
Analog Output (Y)
1 Heating circuit 1 regulation motor
2 Heating circuit 2 regulation motor
3 Analog immersion heater control 0-10V
4 Heating circuit 3 regulation motor/ Adjusment of domestic hot water
5 Speed regulation of brine pump
6 Superheat valve regulation
5.4.3. Running information
This screen shows compressor’s current state.
Etusivulle palataan näytön vasemmassa alakulmassa olevasta painikkeesta. Edelliselle sivulle palataan näytön oikeassa alakulmassa olevasta nuolipai-
nikkeesta. Oikean yläkulman i-painikkeesta avautuu ohjesivu. Toimintahäiriössä yläpalkkiin ilmestyy hälytyspainike.
5.4.4. Heat distribution circuit quantity
There may be from 1 to 3 heat distribution circuits, of which circuits 2 and
3 are optional. If three heat distribution circuits are in use, the domestic
water temperature limit function cannot be used at the same time
5.4.5. Domestic hot water temperature limit
This screen allows activation of the
domestic hot water temperature
limit and changing of the domestic hot water temperature sensor and the
related position valve connection location. The default setting is that the
temperature sensor is connected to analog input B8 and position valve to
analog output Y4 .
5.4.6. Positioning valve control
This screen allows determining the settings of position valves associated
with heat distribution circuits and domestic hot water temperature limit.
Each adjustable circuit has two setting screens.