© Lampert Werktechnik GmbH
2013
11
SELECTION OF THE WELDING PARAMETERS ON PUK D2:
The welding parameters are set in two stages:
1.
In the upper area of the display, the metal to be welded is selected by means of pressing the
arrow buttons.
2.
Pressing one of the 5 buttons in the centre of the display selects the given welding situation.
This selection causes numerous settings to be made in the background. The important information for the user is then
shown on the display:
•
A welding time is preselected and the recommended
setting range for the selected welding situation is
marked next to the scale by means of a blue bar.
Settings outside of the recommended blue setting range
are
always
possible,
however,
they
are
not
recommended for the selected welding situation.
•
The power is also preselected and the recommended
setting range for the power is marked with a blue bar.
Settings outside of the recommended blue setting range
are
always
possible,
however,
they
are
not
recommended for the selected welding situation.
DESCRIPTION OF THE WELDING SITUATION WITH ASSOCIATED SYMBOL ON TOUCHSCREEN:
•
In the start level, the meaning of the following symbols
is always the same for each of the preconfigured
materials.
•
The start level shows in addition to the welding power
and pulse duration for each stored material also the
recommended working range in the respective scales of
the touchscreen, highlighted in colour.
Moving above the predefined values for welding time and welding power turns the colour of the arrow and the parameter
values red from a certain setting. In these ranges, there is a risk of damaging the material being welded, i.e. we expressly
advise you against working in these extreme conditions.
Universal setting for material thicknesses
from 0.3mm. This is well suited for most
applications (
≥
0.3mm).
Setting for thin or delicate parts
less than 0.3mm thick. This setting offers
very low development of heat, especially in
combination with short welding times.
Welding in sharp angles and tight joint
situations. Here it is IMPORTANT to use
short welding times of 2 to 5 ms.
Melting of welding wire. Use identical alloy
wire with a diameter of 0.3 to 0.4 mm. Ideal
is a diameter of 0.35mm.
Very
low-energy
melting
for
welding
(orthodontic) wires or very thin material.
PUSHING/TOUCHING THE RESPECTIVE BUTTON FOR AN EXTENDED PERIOD BRINGS UP AN INFO
WINDOW ON THE DISPLAY. SEE 6.4 "HELP FUNCTION"
