4
3
GENERAL SAFETY INSTRUCTIONS - READ BEFORE USING
3-1 GENERAL SAFETY RULES
A professional may only open the device. Remove the power plug and make sure the
device is not under live power. Always contact your professional if you are uncertain.
Before exchanging the LED module, remove the power supply plug. Only use original
replacement LED modules from Lampert.
It is illegal for non-professional electricians to handle parts that are directly connected to
the mains power supply, except in cases of pulling the mains plug and/or operating the
main power switch.
The device must be disconnected from the mains as soon as repair or service works is
needed. When leaving the place of work even for a short time, make sure that the
electrical outlet is blocked clearly.
If you believe that operating the device is not possible without creating hazardous
conditions, then shut off the device and secure it against unauthorised use.
It is clear that a hazardous conditions are present when:
- the device shows visible damage,or
- or when functional errors occur
- if it no longer functions properly.
3-2 PERSONAL BODY PROTECTION AND DANGERS
EYE PROTECTION DURING WELDING
Do not look into arc without protecting your eyes. Use only a welders’ face
protection shield with protecting glass that conforms to regulation (minimum
protection level 11).
The arc releases not only light and heat causing blindness or burning but also emits UV
rays. If insufficient protection is used, the UV beams can cause very painful conjunctivital
inflammation only noticeable after several hours.
Bystanders close to the arcs also should be made aware of possible dangerous
conditions and should wear protective equipment. If necessary protective walls should be
set up.
EYE PROTECTION WHILST OPPERATING THE LED LAMP
Do not look into the LED Lamp, or into the reflection of the LED light, without eye
protection. Always use a welders’ protective glare shield with a minimum
protection class of 3.
