4
3
4
Preparation of Mounting Parts
Installing Pocket Trigger
5
Verification Before Installing Soft Closer
⑤
Pocket trigger
Insert this end with
the pin.
Pay attention to the direction.
Correct set position
Trigger catcher
Correct set position
If the trigger
position is wrong, pull back the trigger catcher
to the correct position using a 6
mm diameter hard bar.
Improper set position
6
Inserting Parts into Open Area Track
Insert the parts in order from
to
.
You can insert the parts smoothly from the connecting end which has no burrs.
1
3
Front trigger
Upper roller
Soft closer
Pay attention to the direction.
1
2
3
Open area track
The edge which has three countersunk
holes is the end to be connected.
Leading edge
Connecting side
OK
①
Door pocket track
Without verification the self closing feature may fail.
Trigger catcher
(Red colored part)
I
6
⑦
Countersunk head
tapping screw 4 × 20
(not provided)
Casing
Main unit
Lever
Casing
1
2
Remove any dirt or aluminum chips from
the track.
Tape around rollers and upper track to
prevent inserted parts from falling.
Caution
Slot for trigger
Slot for soft closer / roller
Caution
When cutting, reinforce
the track to prevent
deformation at the
cut section.
Caution
(Red colored Part)
Insert the pocket trigger
until it reaches the end
of the track.
