9
必ず、扉が全開位置で
あること（扉の戸尻が
枠に当たっていること）
【
1
】
When determining the trigger position on site
(1) Put a mark on the open area track with reference to the
front end of the door at the fully opened position.
(Use masking tape so that the track isn't marked)
(2) Remove the open area track.
Remove the door according to the procedure -
Appendix 1
: How to remove the door, then remove the
open area track.
・
Drill additional holes for trigger on the open area track.
(See the drawing below.)
[Example] Door pocket track with length equal to the width
of the door pocket.
(1) Drill holes for the pocket trigger according to the drawing below.
(2) Fix the open area track, while following the above right
figure, since the working sequence is different from the
regular process.
【
2
】
How to process the holes for pocket trigger in advance
Front end of the door
30
30
2 x
I
5 additional holes
Mark as front end of the door
Door pocket track
Open area track
The pocket trigger mark
(from the factory)
Pocket trigger
30
Margin
DN
Door width
Width of door pocket = Track length (door pocket)
Opening width = Track length (opened area)
Margin
DN
30
2
×
I
5
additional holes
Position of Leading edge of the door
Door pocket track
Open area track
Leading edge of the door
at full opened position
Mark on pocket trigger
(Factory-made)
Pocket trigger
(3) Mounting open area track
Follow the figure to the bottom right, since the working
sequence is different from the regular process.
(4) Hanging the door
Refer to the procedure
「
」
and the following
procedures on page 3.
2
2
1
Working sequence for mounting the open area track
(common to
【
1
】
and
【
2
】
)
2
1
Pull out the pocket
trigger slightly.
Fasten with screws.
3
Pull out the pocket
trigger and align it
with the drilled holes.
Fasten with screws.
4
How to Shift the Connecting Position of the Tracks
Appendix 2
Put a mark on the open area track
with reference to the leading edge
of the door.
Make sure that the door is
in the fully opened position
(the trailing edge is
touching the frame).
Caution
