Lamona LAM9000, User'S Installation Manual

Page: 5 / 16

4
SAFETY INSTRUCTIONS
WARNING!
Before connecting the appliance
compare the power data (voltage and
frequency) indicated on the
characteristics plate with those of the
power supply in question. If these data
do not match there may be problems. In
case of doubt, contact an electrician.
WARNING!
If the electrical wire plug is removed, the
appliance must be installed and
connected by a technician. Contact a
qualified electrician who knows and
respects current safety standards. The
manufacturer cannot be held responsible
for damage resulting from fitting or
connecting errors.
WARNING!
The electrical safety of the appliance can
only be guaranteed if it is earthed. The
manufacturer cannot be held responsible
for damage resulting from the absence
of or defects in the installation’s
protection system (e.g. electrical shock).
WARNING!
Only use the appliance once it has been
fitted into its built-in position. Only in this
manner can it be guaranteed that users
cannot access the electrical
components.
WARNING!
Never open up the appliance’s frame.
Possible contacts with electrical
conducting parts or changes to electrical
or mechanical components may
represent a danger to users’ safety and
prejudice the correct working of the
appliance.
WARNING!
Repairs and maintenance, especially of
parts carrying electrical current, must
only be done by technicians authorised
by the manufacturer. The manufacturer
and retailers do not accept responsibility
for any damaged caused to people,
animals or property as a result of repairs
and maintenance carried out by non-
authorised personnel.
WARNING!
Repairs undertaken during the
guarantee period must only be done by
technicians authorised by the
manufacturer. If this is not the case then
any damage resulting from the repair in
question is excluded from the guarantee
WARNING!
The appliance must be disconnected
from the electrical current when
installation and repair work is being
done. To disconnect the appliance from
the current, one of the following
conditions must apply:

The switchboard fuses / circuit
breakers must be disconnected.

The plug should be removed from the
socket. To remove the plug from the
socket do not pull on the electric cable
but rather pull out the plug itself
directly.