Lamona LAM9000, User'S Installation Manual

Page: 12 / 16

11
INSTALLATION INSTRUCTIONS
BEFORE INSTALLATION
Check that the input voltage indicated on the
characteristics plate is the same as the
voltage of the power outlet you are going to
use.
Open the drawer and take out all the
accessories and remove the packing material.
WARNING!
The front surface of the crockery heater may
be wrapped in a protective film. Before using
the crockery warmer for the first time, remove
this film carefully.
Make sure that the crockery warmer is not
damaged in any way. Check that the drawer
opens and closes correctly. If you find any
damage, contact the Technical Assistance
Service.
ATTENTION:
The power socket should be easily accessible
after the crockery warmer has been installed.
The crockery warmer should only be built-in
in combination with those appliances
indicated by the manufacturer. If it is fitted in
combination with other appliances, the
guarantee is no longer valid since it is
impossible to guarantee that the crockery
warmer will work correctly.
INSTALLATION
To build-in the crockery warmer in
combination with another appliance there
must be a fixed, interim shelf in the housing
unit to support the weight of both appliances.
The appliance to be combined with the
crockery warmer will be placed directly on the
latter without any need to have a separating
shelf.
To build-in the appliance which is combined
with the crockery warmer, follow the
instructions set out in the respective
instructions and fitting booklet.
The relevant installation dimensions are
indicated in mm in the diagrams shown at the
end of this booklet. Proceed as follows:
1. Place the crockery warmer on the
shelf and slide it towards the interior of the
niche in such a way that it is centred and
completely lined up with the front of the unit.
2.
Check that the crockery warmer’s
frame is properly levelled and is sitting evenly
on the shelf.
3.
Open the drawer and fix the
crockery warmer to the sides of the unit using
the provided screws.
ELECTRICAL CONNECTION
Electrical installation must be performed by
an electrician qualified in accordance with the
legislation in force.
Before connecting the crockery warmer to the
electric mains, check that the voltage and
frequency of the mains matches that which is
shown on the rating plate located in the
heating block inside.
The electric connection is made via an
omnipolar switch, which is suitable for the
intensity to be tolerated and which has a
minimum gap of 3mm between its contacts,
which will ensure disconnection in case of
emergency or when cleaning the crockery
warmer.
If a plug is used for the electric connection,
then it must be accessible after installation.
The connection should include correct
earthing, in compliance with current norms.
WARNING:
THE CROCKERY WARMER MUST BE
EARTHED.
If the flexible supply cable fitted to the
crockery warmer ever needs to be changed, it
should be replaced by an official After Sales
Service, because it requires special tools.
The manufacturer and retailers do not accept
responsibility for any damage that may be
caused to people, animals or property if these
installation instructions are not observed.