8
9
www.howdens.com
Built-in Single Split Cavity Oven
LAM3676
Instructions and Installation
Safety when working with electricity
• Any work on electrical equipment and systems should only be
carried out by author ised or qualified persons.
• In case of any damage, switch off the product and disconnect
it from the mains. To do this, turn off at the fuse box.
• The appliance must be installed so that it can be completely
disconnected from the mains easily after installa tion by the
isolation switch.
• Do not bend or trap cable against hot surfaces during install.
• Make sure that fuse rating is compatible with the product.
•
Do not switch the oven off at the mains isolation switch immediately
after cooking. Cooling fan contin ues to run for up to 20-30 minutes
(approx) even after the oven control is turned off.
• Keep all ventilation slots clear of obstructions, as this may cause
premature failure of the oven element.
• Do not allow the oven to cool with the door open. Even if the
appliances door is only open a little, front panels of adjacent units
could become damaged over time.
Safety and cleaning
•
Do not use harsh abra sive cleaners or sharp metal scrapers to
clean the oven door since they can scratch the surface, which may
result in the shattering of the glass.
•
WARNING:
Ensure that the appliance is switched off before
replacing the lamp to avoid the possibility of an electric shock.
•
Do not use oven light for household room illumination.
•
Do not use steam clean ers for cleaning.
• The appliance must not be installed behind a decorative door.
The oven has 6 shelf positions,
3 of which are in the upper
section, and 3 in the lower section.
There is also a rack gap in the
centre for the middle section
plate to be installed. Do not use
centre rack
A
for placing other
shelves or trays during cooking. It is
important to position the wire shelf
runners correctly before placing
items on the shelf. Do not insert
them forcefully.
The section plate should not be
removed unless the product is fully
cooled down and back at room
temperature.
Where necessary, it is appropriate
to remove the section plate after
the product is fully cooled down.
If the section plate is attached
and removed while the product
is not at room temperature, there
may be jamming.
Placing the wire shelf and tray
onto the wire racks properly
It is important to place the wire
shelf and / or tray onto the rack
properly. Slide the wire shelf or
tray between 2 rails and make
sure that it is balanced before
placing food on it (Please see
the following figure).
Shelf positions
1
2
3
6
5
4
A
A
