Lamona LAM3304, Instructions & Installation Manual

Page: 16 / 28

www.howdens.com
Page _ 16
LAMONA Appliances
Care and maintenance
General information
Service life of the product will extend and the
possibility of problems will decrease if the
product is cleaned at regular intervals.
Risk of electric shock!
Switch off the electricity before cleaning
appliance to avoid possibility of an electric
shock.
Hot surfaces may cause burns!
Allow the appliance to cool down before you
clean it.
• Clean the product thoroughly after each
use. This way it will be possible to remove
cooking residues more easily and will
avoid burning them on the next time the
appliance is used.
• No special cleaning agents are required for
cleaning the product. Use warm water with
washing liquid, a soft cloth or sponge to
clean the product and wipe with a dry cloth.
• Always ensure any excess liquid is
thoroughly wiped off after cleaning and any
spillage is immediately wiped dry.
• Do not use cleaning agents that contain
acid or chloride to clean the stainless steel
surfaces and the handle. Use a soft cloth
with a liquid detergent (not abrasive) to
wipe those parts clean, paying attention to
sweep in a horizontal direction.
The surface may be damaged by some
detergents or cleaning materials.
Do not use aggressive detergents, abrasive
cleaning powder/cream or any sharp objects.
Do not use steam cleaners for cleaning.
Cleaning the control
panel
Clean the control panel and control knobs
with a damp cloth and wipe them dry.
Do not remove the control knobs for
control panel cleaning.
Cleaning the oven door
Don’t use any harsh abrasive cleaners or sharp
metal scrapers for cleaning the oven door. They
could scratch the surface and damage the glass.
Removal of the oven door
1. Open the door.
2. Unlock the clips at the hinge housing on
the right and left hand sides of the door by
pressing them down as illustrated in the
diagram.
1. Door door
2. Hinge
3. Oven
4. Raise the door to the half-way position.
5. Remove the door by pulling it up-wards to
slide it from the hinges.
Steps carried out during removing process
should be performed in reverse order to reattach
the door.
Do not forget to close the clips at the hinge
housing when reinstalling the door.