14/EN
Stability chain to be as short as
practicable to avoid oven tilting
forward and diagonal to avoid oven
side tilting.
Cooker stability chain for cookers is not
designed with bracket engagement slot.
Installation and connection
Product can only be installed and connected
in accordance with the statutory installation
rules.
Do not install the product next to
refrigerators or freezers. The heat
emitted by the product will increase
the energy consumption of cooling
appliances.
•
Carry the product with at least two
persons.
•
Product must be placed directly on
the floor. It must not be placed onto
a base or a pedestal.
Do not use the door and/or handle
to carry or move the product. The
door, handle or hinges get damaged.
Electrical connection
Connect the product to a grounded outlet/line
protected by a fuse of suitable capacity as
stated in the "Technical specifications" table.
Have the grounding installation made by a
qualified electrician while using the product
with or without a transformer. Our company
shall not be liable for any damages that will
arise due to using the product without a
grounding installation in accordance with the
local regulations.
DANGER:
The product must be connected
to the mains supply only by an
authorised and qualified person.
Manufacturer shall not be held
responsible for damages arising
from procedures carried out by
unauthorised persons.
DANGER:
The power cable must not be
clamped, bent or trapped or
come into contact with hot parts
of the product.
A damaged power cable must be
replaced by a qualified electrician.
Otherwise, there is risk of electric
shock, short circuit or fire!
The mains supply data must correspond to
the data specified on the type label of the
product. The rating plate is either seen when
the door or the lower cover is opened or it is
located at the rear wall of the unit depending
on the unit type.
Power cable of your product must comply with
the values in "Technical specifications" table.
DANGER:
Before starting any work on the
electrical installation, disconnect
the product from the mains
supply.
There is the risk of electric shock!
Connecting the power cable
1. This product must only be connected
by a qualified electrician such as a
technician from the local electricity
company or NICEIC registered
contractor to a suitable double-pole
control unit with a minimum contact
clearance of 3 mm in all poles. This
control unit must be installed in
accordance with the IEE directives.
Failure to obey this instruction may
cause operational problems and
invalidate the product warranty.
Additional protection by a residual
current circuit breaker is recommended.
