LAMBERTI ELEKTRONIK DFW HZR, Operating And Commissioning Manual, Page: 5 / 16

P
a
g
e
5
7. Wall mounting of the digital remote control
71,5 mm
7
1
,5
m
m
1. Select a suitable mounting location in the room, in
which the temperature should be adjusted (e.g. liv-
ing room). Take care, that no external heat can in-
fluence the remote control!
2. Remove the housing cover of the remote control!
Here it is important to press the housing cover
slightly together at the top and at the bottom side!
3. Mark the two mounting holes (see drawing) and
drill (Ø 5 mm), fit in the enclosed dowels!
4. Align the housing trough to the wall and fix it with
the two screws!
5. Carry out the electrical connection!
6. Clip on the housing cover!
Danger of personal injury!
Never use the housing trough of the remote control as drilling template!
DANGER
8. Electrical connection of the remote control at the heating controller
Attention!
Please also consider the information about the electrical connection in the commissioning manual of
the heating controller!
!
Danger to life due to electric shock!
Switch off the power supply of the heating controller every time before the clamp cover is opened!
Make sure, that the controller cannot be switched on!
DNAGER
Connect the remote control to the heating controller. Use a 2-wire weak-current line and connect it via screw
terminals (single / fine wire, max. 1,5 mm
2
) according to the wiring diagram of the heating controller.
Patch the eBus connection (+ and -) of the heating controller directly with the bipolar connecting terminal of
the remote control. The polarity
need not to be observed! A suitable strain relief has to be provided!
The low voltage conducting lead has to be laid separately to power supply voltage conducting leads. Now
mount the clamp cover again on the heating controller and clip on the housing cover of the remote control.
The digital remote control is automatically detected by the heating controller during the first commis-
sioning of the remote control. This procedure may last a few seconds!
Danger to life due to electric shock!
The remote control may never be mounted on a flush socket, in which there is already power supply
voltage! Make sure that there is only a weak-current line in the flush socket!
DANGER
Wall mounting of the digital remote control