REV C
Page 13 of 17
Inhibit Module (J1 pin 6 - single output module, J2 pin 1 - dual output module):
A TTL "low" level signal can be applied to disable outputs to <0.5V at no load.
Output Good Signal (J1 pin 7):
This signal goes low if output deviates by - 4% from factory settings.
Module Inverter O.K. Signal (J1 pin 8):
If an output module inverter fault is detected this output goes high. This signal causes the
current-share node to disconnect. Maximum ratings for the output transistor are 20V/4mA.
Current Monitor (J1 pin 9):
This is an analog signal proportional to the output current, 0-2VDC (2VDC at max output
current). From 20%-100% of current rating the accuracy will be within 10% of the max rated
current value.
-Remote Sense (J1 pin 10 –single output module, J2 pin 2 & 5 – dual output module):
Compensates for load cable drop from power supply to sense point (.25V per terminal.) To
meet module specifications the remote sense must be connected to the load or locally to the
power supply.
