A
SSEMBLY
STAGE
#4
Attach Seat Rail & Seat Assembly to the Main Base
Assembly Hardware Required:
#31 Truss Head Hex Socket Screw
Qty. 8
#25
Flat Washer
Qty. 8
Assembly Description:
A) Slide the
Seat Rail
(#7) through the sleeve insert of the Seat Frame (#10) (Reference
Figure #2
).Note: Be
careful not to damage the Seat Rail / Heart Rate Cable (#22).
B) Once the Seat Rail has been inserted through the Seat Frame sleeve, center the Seat Frame in the middle of
the Seat Rail and use the
Adjustment Knob
(#23) to lock the seat in position. Note: After the Seat frame
is locked into position hole, turn the knob (clockwise) to securely lock the Seat Frame in place.
C) Rest the Seat Rail assembly on back end of the Seat Support mounting plate. Connect the
Seat Rail /
Heart Rate Cable
(#22) to the
Lower
Heart Rate Cable
(#19), as shown.
D) Tuck excess cable length inside the Seat Rail and slide the front end of the Seat Rail over the end of the
middle extrusion of the Main Base (#1). Note: Be Careful not to damage the heart rate cables. Secure the
Seat Rail in place using 4-
Truss Head Hex Socket Screws
(#31) and 4-
Flat Washers
(#25), but do not
fully tighten the mounting hardware. (Reference
Step #10
on the enclosed hardware pack)
E) Align the Seat Rail rear mounting holes with the Seat Support mounting plate. Secure the Seat Rail in
place using 4-
Truss Head Hex Socket Screws
(#31) and 4-
Flat Washers
(#25). (Reference
Step #11
on
the enclosed hardware pack)
F) Securely tighten all the hardware used to assemble the Seat Support (#6) and Seat Rail (#7) to the
Main Base, including the assembly hardware located under the Cap / Cover (#8).
G) Plug the
Seat Rail / Heart Rate Cable
(#22) into the receptacle located on the back of the Handlebar
Assembly (#9). (Reference
Figure #3
)
♦
Assembly Stage #4 completed
A
SSEMBLY
I
NSTRUCTION
P
AGE
8
1
31
25
25
31
19
22
22
23
7
Figure #2
Figure #3
USE TOOL
8
9
