Lake Shore 625, User Manual

Page: 80 / 132

Lake Shore Model 625 Superconducting MPS User’s Manual
5-26 Computer Interface Operation
Message Strings (Continued)
A query string is issued by the computer and instructs the instrument to send a response. The query format is:
<query mnemonic><?><space><parameter data><terminators>.
Query mnemonics are often the same as commands with the addition of a question mark. Parameter data is often
unnecessary when sending queries. Query mnemonics and parameter data if necessary is described in Paragraph 5.3.
Terminators must be sent with every message string. The computer should expect a response very soon after a query is
sent.
A response string is the instruments response or answer to a query string. The instrument will respond to the last query or
queries it receives. The response can be a reading value, status report or the present value of a parameter. Response data
formats are listed along with the associated queries in Paragraph 5.3. The response is sent as soon as possible after the
instrument receives the query. Typically it takes 10 ms for the instrument to begin the response. Some responses take
longer.
5.2.6 Message Flow Control
It is important to remember that the user program is in charge of the serial communication at all times. The instrument
cannot initiate communication, determine which device should be transmitting at a given time or guarantee timing
between messages. All of this is the responsibility of the user program.
When issuing commands only the user program should:
•
Properly format and transmit the command including terminators as one string.
•
Guarantee that no other communication is started for 50 ms after the last character is transmitted.
•
Not initiate communication more than 20 times per second.
When issuing queries or queries and commands together the user program should:
•
Properly format and transmit the query including terminators as one string.
•
Prepare to receive a response immediately.
•
Receive the entire response from the instrument including the terminators.
•
Guarantee that no other communication is started during the response or for 50 ms after it completes.
•
Not initiate communication more than 20 times per second.
Failure to follow these simple rules will result in inability to establish communication with the instrument or intermittent
failures in communication.
5.2.7 Serial Interface Example Programs
Two BASIC programs are included to illustrate the serial communication functions of the instrument. The first program
was written in Visual Basic. Refer to Paragraph 5.2.7.1 for instructions on how to setup the program. The Visual Basic
code is provided in Table 5-9. The second program was written in Quick Basic. Refer to Paragraph 5.2.7.2 for
instructions on how to setup the program. The Quick Basic code is provided in Table 5-10. Finally, a description of
operation common to both programs is provided in Paragraph 5.2.7.3. While the hardware and software required to
produce and implement these programs not included with the instrument, the concepts illustrated apply to almost any
application where these tools are available.