21.
Warning.
The use of any accessory or attachment other than one recommended in this instruction manual may
present a risk of personal injury.
22.
Have your tool repaired by a qualified person.
This electric tool complies with the relevant safety rules.
Repairs
should only be carried out by qualified persons using original spare parts, otherwise this may result in considerable
danger to the user.
23.
Never use the machine if the appropriate guard is not in place and correctly adjusted.
24.
Do not use knives which are blunt as this increases the danger of kickback.
25.
Any portion of the cutter block not being used for planning shall be guarded.
26.
When planning short work pieces, a push stick should be used.
27. When planning narrow work pieces, additional measures, such as the use of horizontal pressure devices and
spring-loaded guards, may be necessary to ensure safe working.
28. The effectiveness of the device for the prevention of kickback and the feed roller should be regularly inspected to
ensue safe operation.
29. Tool equipped with chip collection and extraction hoods shall be connected to the Woodworking can be dangerous if
safe and proper operating procedures are not followed. As with all machinery, there are certain hazards involved with the
operation of the product. Using the machine with respect and caution will considerably lessen the possibility of personal
injury. However, if normal safety precautions are overlooked or ignored, personal injury to the operator may result. Safety
equipment such as guards, push sticks, hold-downs, featherboards, goggles, dust masks and hearing protection can
reduce your potential for injury. But even the best guard will not make up for poor judgment, carelessness or inattention.
Always use common sense and exercise caution in the workshop. If a procedure feels dangerous, do not try it. Figure out
an alternative procedure that feels safer.
REMEMBER:
Your personal safety is your responsibility.
ADDITIONAL SAFETY RULES FOR HOLLOW CHISEL
MORTISERS
1.
DO NOT OPERATE THIS MACHINE
until it is
assembled
and
installed
according to the instructions.
2.
OBTAIN ADVICE FROM YOUR SUPERVISOR, instructor, or another qualified person
if you are not familiar
with the operation of this machine.
3.
FOLLOW ALL WIRING CODES
and recommended electrical connections.
4.
MAKE CERTAIN
the machine is fastened to a supporting surface to prevent it from tipping over during operation.
5.
NEVER
turn the mortiser
“
ON
”
before clearing the table of all objects (tools, scrap pieces, etc.).
6.
ALWAYS
keep hands, fingers and hair away from the rotating bit.
7.
DO NOT
attempt to mortise material that does not have a flat surface, unless a suitable support is used.
8.
ALWAYS
position holddown directly over workpiece to prevent workpiece from lifting during operation.
Summary of Contents for MS36127A3
Page 12: ...Parts Diagram ...
Page 13: ...Parts List ...
