Laizhou Huibang Machinery MS36127A3, Owner'S Operating Manual

Page: 4 / 15

9. ALWAYS support workpiece securely against fence to prevent rotation.
10. BE SURE drill bit is sharp, not damaged, and properly secured in the chuck before operation.
11. MAKE SURE chuck key is removed before starting machine.
12. NEVER turn on the power with the drill bit or chisel contacting the workpiece.
13. NEVER perform layout, assembly, or set-up work on the table while the mortiser is operating.
14. ADJUST the depth stop to avoid drilling into the table.
15. ALWAYS turn off the power before removing scrap pieces from the table.
16. SHUT-OFF the power, remove the drill bit and chisel, and clean the table before leaving the machine.
17. FOR YOUR OWN SAFETY
–
Don
’
t wear gloves when operating the machine.
18. SHOULD any part of your tool be missing, damaged, or fail in any way, or any electrical component fail to perform
properly, shut off switch and remove plug from power supply outlet. Replace missing, damaged, or failed parts before
resuming operation.
19. THE USE of attachments and accessories not recommended by Delta may result in the risk of injuries.
20. TURN THE MACHINE
“
OFF
”
AND DISCONNECT THE MACHINE from the power source before installing or
removing accessories, before adjusting or changing set-ups, or when making repairs.
21. TURN THE MACHINE
“
OFF
”
, disconnect the machine from the power source, and clean the table/work area
before leaving the machine. LOCK THE SWITCH IN THE
“
OFF
”
POSITION to prevent unauthorized use.
WARNING: FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURY.
SAVE THESE INSTRUCTIONS.
Refer to them often
and use them to instruct others.
CONNECTING TOOL TO POWER SOURCE