Laing Innotech GmbH + Co. KG Althuette Germany Instruction LTC 11
- 28 -
Configuration of the controller though the “LD” control panels (with height
indication)
Operation of “LD” control panels with two buttons
The LD control panels without memory keys cannot use the memory one and
memory two key for the menu handling.
For these control panels:
•
Scrolling can only be done by the “Up” arrow key
•
Instead of the memory one key, press the “down” arrow once
•
Instead of the memory two key, press the “down” arrow twice
Store memory positions by the “LD” control panels
•
Move the table top by use of the arrow keys to the desired height
•
Press the Memory key, this height should be assigned to, 4 times quickly
one after another. Now the present position of the table is stored in the
selected memory position
Memory key handling by the “LD” control panels
In this menu item, it can be selected if the memory position key must be kept
pressed until the memory position is reached or if one key press is sufficient
•
Press the “up” arrow key 4 times quickly one after another
•
Reaching the program mode will be confirmed by a sound
•
The display will now show P01
•
Press the “up” or “down” arrow key until the display shows P05
•
Press the memory one key once shortly
•
The display shows one or zero.
o
If it shows “1” the Memory key must be kept pressed until the
desired height stored under the memory position is reached.
o
If it shows “0” the Memory key must be pressed only once, then the
table will move to the desired height stored under the memory
position.
•
By using the arrow keys the indication can be toggled from “1” to “0”. Once
the right selection is made push the “memory one” key to confirm the
selection, a sound will confirm that the setting is stored, the display will go
back to normal operation and indicate the height
•
When the selection is set to “0” the table will move into the stored memory
position until the position is reached. Make sure that such an “automatic”
operation is allowed in the country the table is operated. If not, you must
select the selection “1” where the movement can be stopped by releasing
the key