Laing Innotech GmbH + Co. KG Althuette Germany Instruction LTC 11
- 10 -
Installation of the controllers
Controllers without OptoSense
The controller will be attached to the bottom of the table top by two screws, one
on each fixing point at the ends of the controller. A suitable fastener size is #8
wood screw. The length is determined by the thickness of the table top, however
it should be a minimum of ½ inch. When using other size screws, it is important,
that the shaft of the screw is not wider than the slot in the fixing point and that the
head is not bigger in diameter than 3/8 inch. The torque is determined by the
material of the table top, it is important, that the fixing points at the endcap of the
controller not be deformed!
The controller can also be mounted on the cross bar, in this case the mounting
can be done by M4 metric screws with a spring washer to secure the connection.
Important!
When the GyroSense option is used, the controller must be mounted
onto the table top to insure proper operation.
Controller with OptoSense
The controller with OptoSense can only be mounted directly below the table top.
It cannot be mounted onto the cross bar!
The picture shows a cross section
through the controller and the table
top. It can be seen, that the centering
stud of the controller endcap reaches
into hole in the table top to position
the controller.
The picture shows the OptoSense
sensor, what has to be inserted
into the top of the controller
through a hole in the table top.