laguna Smart Shop M2, Owner'S Manual

Page: 31 / 75

Smart Shop "M" Maker 2 31
Multiple Tool Program
Tool Cone Set-Up
This section is a work flow, from turning the machine on, to starting your program.
This walk through assumes only TOOL 1 is used.
1.Power on Machine.
2.Home Machine.
3.Verify that the machine is connected to an air supply.
*1.) “Power on Machine”
•Turn the rotary switch to the “
ON ” position.
•Turn the key to the “ ON ” position.
•Press the Control Power “ ON/OFF ” button located on the control panel.
*2.) “Home Machine”
“Verify that the machine is connected to an Air Supply.”
a.The tool changer needs
6 bar-6.5 bar or 87 psi-95 psi .
b.Use the pressure regulators (See Figures Below) on the back of the machine to adjust air pressure.
Set 6 bar-6.5 bar or 87 psi-95 psi Set at 0.5 psi or 7.25 psi