laguna MT01002, Manual, Page: 30 / 49

1. Loosen the clamping screws at each end of the sliding table.
2. With a brass rod, knock the rod out +1”.
3. Rotate the rod +20 degrees.
4. With the brass rod, knock the rod back level with the end of the table
and retighten the clamping screws.
5. Repeat until all the rods have been turned.
Troubleshooting
Poor cut
1.
Cutter head not fitted to the bottom of the shaper spindle. Reposition
the cutter on the spindle.
2. Cutter blades blunt. Replace or re-sharpen the blades.
3. Tilt or vertical movement hand wheels not locked. Lock the movement
wheels.
4. Direction of cutter rotation incorrect.
5. Over feeding the job. Slow the feed rate.
Machine will not start
1.
Check that the start switch is being depressed fully.
2. Check that the electrical power cord is plugged into the power outlet.
3. Check that the electrical supply is on [reset the breaker].
4. With the power disconnected from the machine, check that the wiring
in the plug is correct. Check that the rubber insulation is stripped
enough and is not causing a bad connection. Check that all the screws
are tight.
5. With the power disconnected from the machine, check that the wiring
to the machine plug is correct. Check that the rubber insulation is
stripped enough and is not causing a bad connection. Check that all
the screws are tight
6. Check that you have the correct power: 220V not 110V
7. Check that the earth wire is wired correctly
8. Check that the door is closed.
9. Check that the emergency stop switch is in the full out position.
10. Check that the internal breaker is not tripped.
The machine will not stop
This is a very rare occurrence as the machine is designed to be fail-safe. If it
should occur and you cannot fix the fault, seek professional assistance. The
machine must be disconnected from the power and never run until the fault
has been rectified.
1.
Stop switch faulty. Replace the stop switch.
2. Internal contactor faulty. Replace the contactor.
30