laguna MT01002, Manual, Page: 20 / 49

The side extension table comes with
the clamp bar attached. Loosen the
ratchet handles and slide the bar
into the slot on the side of the side
of the sliding table. Attach the table
and level as follows
To adjust the side extension
table, lay a straight edge level on
the sliding table and extended
over the side extension table.
Loosen the two clamping handles;
adjust the vertical adjustment
screws so that the edge of the
side extension table is level
with the sliding table. Re-
clamp and re-check with the
straight edge.
To get the side extension table
parallel with the sliding table
adjust the two plastic screws
located under the table. Only
adjust the screws with the
ratchet clamp handles loose.
Side extension table
Side table adjustment
Flip stop
Vertical
adjustment
screws
Sliding table, side extension table
Straight edge
Plastic
adjusting
screws
Mitre fence
The miter fence [Cross cut fence] Fit the “T” bolt into the sliding table slot.
Fit the clamp shaft through the casting into the “T” bolt and tighten.The
machine is provided with a flip fence stop [shown in the up and down
position] that is factory set. Some adjustment may be necessary and can
be achieved by loosening the lock nut, adjusting the bolt and then re-
clamping the lock nut.
19