
Fitting the electrical
cable
The CEE plug and
socket are located on
the side of the
machine above the
dust port. The
electrical cable is fitted
as shown.
Releasing
socket cover
You will see a wire that
is yellow and green or
green, which is the
ground wire; the other
colored wires are
power. It does not
matter what color
combination you use. Green and yellow or green is
ground; all other wiring is power (there is no neutral). On 3-phase machines
it does not matter what color combination you use. Green [yellow/green or
green] it is ground; all other wiring is power (there is no neutral]. If the
spindle rotates in the wrong direction you need to swap locations of 2 of the
power leads, and it will rotate in the correct direction.
Plug wiring
CEE plug
and socket
Before starting the machine
1.
Read and understand the instruction manual before operating the
machine.
2.
If you are still not thoroughly familiar with the operation of the machine,
get advice from a qualified person.
3.
Make sure the machine is properly grounded and that the wiring codes are
followed.
4.
Do not operate the machine while under the influence of drugs, alcohol,
and medicine or if tired.
5.
Always wear eye protection, safety glasses or a safety shield, and hearing
protection.
6.
Wear a dust mask; long-term exposure to the fine dust created by the
machine is not healthy.
7.
Remove your tie, rings, watch and all jewelry. Roll up your sleeves, and
never wear any loose fitting clothing. You do not want anything to get
caught in the machine.
8.
Make sure that the guards are in place and use them at all times. The
guards protect you from coming in contact with the cutter.
9.
Make sure that the cutter blades point in the correct direction.
10.
Stop the machine before removing the scrap piece from the table.
11.
Always keep your hands and fingers away from the cutters.
12.
Make sure that you use the proper size and type of cutters.
14.
Use a push stick at the end of a cut. This is the most dangerous time
because the cut is complete. Push sticks are commercially available.
14
Summary of Contents for MT01002
Page 33: ...33...
Page 35: ...1001 02 00 00 00 Cutter 35...